These instructions are intended to be used as a guide only. If you are not comfortable using tools, performing general maintenance, raising your motorcycle into the air or if your coordination is not too good or if you are just generally a klutz (sorry but I don't want anyone hurt or complaining) then it might be better to go to the shop or have a friend help. Good luck and buy some more chrome with the money you save...Bob

Cleaning the Valkyrie Crankcase Breather

documented by

Carl Kulow

 

 

 

Parts                                                                                       Tools

none                                                                                        slip joint pliers

 

 

1.      Locate the 3 drain hoses below the right foot peg

2.      Note that one of the hoses has a plug and clamp on the end of it

3.      Squeeze the clamp with the pliers to open it slightly and slide the clamp up the hose ~1 inch

4.      Pull the plug from the hose and let it drain

5.      Install the plug

6.      Slide the clamp back down over the plug using the pliers